Reviews on Edc15c11 Read write with kess, ktag, mpps, galletto

To read and write Bosch edc15c11 for a Volvo xc90 2.4d5 2005 model, which ecu programmer? how? what about kess, ktag, mpps etc?

1. MPPS: worked

Only boot mode
I’m did this ECU in boot with MPPS 

2. Kess V2 via bootmode: worked

I made a few of these ECUs from Kess V2 via bootmode without any problems.

Guide: Use the help files of ksuite… its easy…

3. fgtech galletto: worked

I read EDC15C11 just a few days ago with fgtech galletto

and used the diagram posted below:

No problem reading/writing. FYI, you have to make checksum before writing new file, since galletto does not support chksum correction on these ECUs

4. MPPS: worked too

Mpps in bootmode, use bosch generic protocol. Works fine done it several times.
Ore you can desolder chip and use a eprom programmer.
I had no sucsess with kess ore ktag. Ktag would only write backup, and not the 29f200 only.
I use ktag to make backup, and read and write 29f200 with mpps in bootmode.

5. fgtech galletto on boot mode… very easy.

Read documents boot mode fgtech…

 

Good luck!